Table of Contents
Advertisement
Rev 1.0 May.10
Mounting
An optional accessory for your Raven XT is a mounting kit, which includes a
bracket. The bracket is designed to snugly cradle the modem and hold it in place
where you need it. You can use a strap around the bracket and modem for extra
security. The bracket can be attached to a stationary location using #6 screws
with the mounting hole diameter approximately 0.150".
The instructions to bracket installation is following:
1. Mount the bracket using number 6 screws. There are two holes each, to
fasten screws, and minimum of one hole each end is required for mounting
bracket.
2. Position Raven XT between Alignment ears.
3. Engage top groove in body of Raven XT with two tabs.
4. Push on far side of Raven XT in center so that it touches side of Bracket.
5. Press down and release when upper groove on far side of Raven XT, aligns
with tabs.
6. Release to complete installation in to mounting bracket.
To remove, press on the two edges of the modem and the brackets, as pointed by
arrows in the diagram provided below. By doing this, the modem will snap out of
the mounting bracket.
Figure 4-5: Optional Mounting Bracket
Hardware Installation of the Raven XT
21
Advertisement
Table of Contents
