Table of Contents
Advertisement
Rev 1.0 May.10
Connecting to a Computer or other
Device
Figure 4-3: USB
Your Raven XT's full-speed (12 Mbit) USB 2.0 port can be connected directly to
most computers or other devices using a standard full-speed USB 2.0 cable. If the
computer or device you are connecting or the cable is not rated for full-speed, the
modem will communicate at a reduced speed to match. The Raven XT functions
as a device, not a host.
When it is connected to a computer, the USB port should be seen as a COM port
or Ethernet port after the applicable driver is installed.
The Raven XT has a standard mini-B connector.
Warning:
The USB port can only be used in a non-hazardous environment.
Indicator Lights
When solid, Raven XT indicates a successful connection. When your Raven XT is
connected to power and an antenna, there is a specific pattern to the lights to
indicate its operation mode.
Figure 4-4: Raven XT Indicator lights
•
Network - Indicates a successful connection to the cellular network with an
IP address given and a channel acquired.
•
Signal - Light shows the strength of the signal and may be nearly solid
(strong signal) or flashing (weaker signal). A slow flash indicates a very weak
signal.
Hardware Installation of the Raven XT
19
Advertisement
Table of Contents
