Raider RDP-CDLCAG03 User Manual page 31

18.18. Check the status of the charger, cable, and plug before each use. In the event of faults, do
not use the charger. Do not attempt to disassemble the charger. All repairs should be assigned to an
authorized repairer. Incorrect installation of the charger may result in electric shock or fire.
18.19. When the charger is not in use, it must be disconnected from the mains.
18.20. It is forbidden to repair a damaged charger. Carrying out the repair of the charger is only
permitted by the manufacturer or an authorized service center.
19. Protection against environmental impact.
19.1. Protect the charger and the batteries from moisture and rain. Moisture and rain can cause
dangerous damage.
19.2. Do not use a charger or battery near flammable vapors and liquids.
19.3. Use the charger and the battery only in dry places and at an ambient temperature of 0-45 ֯ C.
19.4. Do not store the charger and battery in places where the temperature may reach over 30 ° C. In
particular, do not leave the charger in a car parked in the sun.
19.5. Protect the batteries from overheating. Overloading, overcharging, and exposure to direct
sunlight will result in overheating of the cells. Never charge or operate batteries that have overheated -
replace them as soon as possible.
19.6. Storage of batteries, chargers and rechargeable tools. Conditions for use.
Store the charger and the battery charger only in a dry place and at an ambient temperature of 10-30
° C. Protect them from moisture and direct sunlight. Only recharge fully charged rechargeable batteries /
charged at least 40% /. When operating, use the battery charger, angle grinder and battery only in a dry
place and at an ambient temperature of 0-45 ֯ C.
19.7. Protect the lithium-ion battery from frost. Rechargeable batteries that are stored below 0 ֯ C for
more than 60 minutes should be discarded.
19.8. When handling batteries, be aware of the electrostatic charge. Electrostatic discharges cause
damage to the electronic protection system and battery cells. Beware of the electrostatic charge and
never touch the battery poles.
20. Maintenance and service.
20.1. Maintenance and cleaning.
To work well and safely, keep the angle grinder and the ventilation openings clean. Make periodic
breaks in work. Store and handle the accessories carefully.
Wipe the machine with a clean cloth or blow it with compressed low pressure air. Clean it regularly
with a damp cloth and a little soft detergent. Do not use detergents or solvents.
20.2. Replace carbon brushes.
Worn (shorter than 5 mm), hot or broken carbon brushes on the engine should be replaced
immediately. Always replace the two brushes at the same time. Only use a carbon brush changeover to a
qualified person using original parts in a RAIDER Authorized Service Center.
20.3. If an abnormal noise occurs on the angle grinder, stop working immediately and contact your
nearest RAIDER service center.
21. Environmental protection.
21.1.In order to protect the environment, the power tool and packaging must be suitably processed
for the re-use of the raw materials contained therein. Do not dispose of power tools in household waste!
According to the European Union Directive 2012/19 / EC on end-of-life electrical and electronic devices
and the validation and as a national law, power tools that can no longer be used must be separately
collected and subjected to appropriate processing for the recovery of the contents raw materials.
21.2. Rechargeable battery.
Lithium-ion battery (Li-ion).
Do not dispose of batteries in household waste or in water tanks! Do not burn them!
Batteries should be collected, recycled or disposed of in an environmentally friendly way. According
to Directive 2006/66 / EC, faulty or waste batteries or batteries must be recycled.
31