Advertisement
Mounting to a Concrete Wall
2b
1
Hold the marking template (H) provided against the wall where you want to install the TV,
mark six holes for drilling.
70mm
70mm
(2.7")
(2.7")
ø 10mm
(ø 3/8")
2
Using a power drill and a 3/8" masonry drill bit, drill mounting holes of 3/8" (10 mm) diameter
and 2.7" (70 mm) depth at the marked locations in the previous step.
5
H
Marking Template
QG-T M-03 1-BLK
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
A
Wall Plate
3 Place concrete anchors (W-B) in each hole. Tap each anchor flush with the wall using a hammer.
Using a socket wrench, mount the wall plate (A) and fasten them with the provided lag bolts
(W-A) and D6 washers (W-C).
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
D
Bubble Level
Insert the bubble level (E)
on the wall plate (A)
W-B
W-C
W-A
WARNING
6
Advertisement
