Page 1
Please check that the desk mount is secure and safe to use at regular intervals. If you have any questions regarding any of the instructions or warnings; please contact your local distributor directly (OR) contact QualGear technical support via email at support@qualgear.com. Scan the QR Code™ below...
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage to the items. This greatly reduces their holding power. • All QualGear products are intended for indoor use only and any outdoor use voids the limited warranty.
Page 3
1a Edge Installation 1b Grommet Installation NOTE Insert security pin of desk clamp assembly (C) in Pole one of the small two holes of pole (B) to center align them. Silicone Pads For grommet installation, disassemble the desk clamp (C) and Attach the desk clamp assembly (C) select the right parts.
Page 4
Installing The Adapter Bracket Assembly 3a Attaching The Display (For VESA 100x100mm) Choose appropriate screws and washers according to your Adapter Bracket display. Assembly Attach the screws for the top two holes on the back Cable Clip of your display. Tighten them using a Philips screwdriver leaving a 3mm clearance.
Page 5
Attaching The Display (For VESA 100x100mm) 3b Attaching The Display (For VESA 75x75mm) HEAVY! You may need assistance with this step. HEAVY! You may need assistance with this step. M -C Choose appropriate screws and washers according to your display. Install both screws through the lower mounting holes on the VESA plate into the display.
Adjustments Cable Management 360° +45° -45° Connect cables to your display and route through the cable clip and along the arms. Allen Key Allen Key Allen Key To adjust the display to a desired tilting position, using a 6mm Allen Key (J), slightly loosen or tighten the adjustment screws based on the weight of the display.