Advertisement
Installing the Decorative Covers
1
When decorative covers are installed correctly,
there will be a gap between the bottom of the wall
NOTE
plate and the decorative covers. This gap is for the
safety bar installation on Step 5.
F
Attach the decorative covers to the wall plate using the screws.
Mounting to a Wooden Stud Wall
2a
Stud Finder
1
Using an edge-to-edge stud finder, find the
edges of the stud.
3
Decorative Cover
G
ST2.9x6.5 Screw
For concrete wall
NOTE
mounting, follow
Step 2b.
2
Using a level, mark the centerline of the stud.
H
K
QG-TM -031-BL
3
Using the marking template (H) provided,
mark four holes for drilling on the centerline of
the stud.
A
Wall Plate
5
Mount the wall plate (A) and tighten it with the provided
lag bolts (W-A) and D 6 washers (W-C) using a socket wrench.
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
WARNING
Make sure that mounting screws are anchored into the center of the studs. The use
of a stud finder is highly recommended.
Installers are responsible for providing hardware for other types of mounting situations.
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
65mm
65mm
(2.5")
(2.5")
ø 4.5mm
(ø 3/16")
4
Using a power drill and 3/16" drill bit, drill
pilot holes of 3/16" (4.5 mm) diameter and at
least 2.5" (65 mm) depth.
E
Bubble Level
Insert the bubble level (E)
on the wall plate (A)
W-C
W-A
SKIP TO STEP 3
4
Advertisement
