Page 1
Installing the Safety Bar and the Padlock QG-TM-031-BLK Make sure the TV is safely secured before releasing IMPORTANT: HEAVY DUTY TILTING TV WALL MOUNT Padlock is not included The folded edge faces inward. Insert the safety bar onto the rail (at the bottom of Safety Bar the wall plate) to secure.
Before starting installation, please check that all parts shown in this checklist IMPORTANT: are included. If any parts are missing or damaged, contact your local distributor or support@qualgear.com for replacement parts and do not start assembly and installation WARNING until you receive all the parts.
Page 3
Installing the Decorative Covers 65mm 65mm (2.5") (2.5") When decorative covers are installed correctly, ø 4.5mm there will be a gap between the bottom of the wall NOTE (ø 3/16") plate and the decorative covers. This gap is for the safety bar installation on Step 5.
Page 4
Mounting to a Concrete Wall NOTE Do NOT use power drill and do NOT over tighten the lag bolts. Bubble Level Insert the bubble level (E) Marking Template on the wall plate (A) QG-T M-03 1-BLK Wall Plate Hold the marking template (H) provided against the wall where you want to install the TV, mark six holes for drilling.
Page 5
Installing to a Flat Back Panel of a TV M-A/ M-B Flat Back Choose the appropriate screws and washers according to the type of your TV, and attach adapter brackets (C and D) to the back of the TV using a Panel Phillips screwdriver.
Installing to a Curved or Recessed Back Panel of a TV Choose the appropriate screws, washers, and spacers (if necessary) according to the type of your T V and attach adapter brackets (C and D) to the back of the TV using a Phillips screwdriver. M-D/ M-E/ M-F 8.5mm IMPORTANT!