Table of Contents
Advertisement
ALWAYS wear the kill switch strap around your wrist when riding. This is
to prevent further damage to the rider, the vehicle or other property. When
falling, losing control or feeling unsafe, release your right hand from the
handlebar and pull it back, this will disconnect the kill switch and turn the
bike off.
ALWAYS disconnect the kill switch when not riding. As the bike is electric,
it's hard for bystanders to know if the bike is on or not. This can cause
accidents if people are pulling the throttle while expecting a turned off bike.
Brakes
As the Kalk& bike is built for off-road use, it does not have ABS brakes to give
the rider full control over the bike when riding in off-road conditions. Please
be cautious not to lock the wheels when braking in traffic. The front brake is
located on the right side on the handlebar, and the rear brake is located by
the right foot peg and is operated by the right foot.
Display
The display on the stem is the bike's control panel. Here, you will be able
to see the speedometer, odometer, trip meter, power mode, brake mode,
service intervals, warning signals and limiters and error codes.
Operating the display
When the bike has been turned on, press the upper, white display button to
activate the bike.
Changing Power mode
When the bike has been activated, press the middle button on the display
to change power mode. You will always change the power mode, starting
from "Mode 1" to "Mode 2" to "Mode 3" to "Mode C" and back to "Mode 1"
again, one press at a time. The bike will make a different sound depending
on the selected power mode.
Note: If you don't have power mode C in the display, but do have a
connectivity module, you need to create an account in the app and configure
the custom power mode.
Advertisement
Table of Contents
