Tools - Cake Kalk& Manual

yellow connector on the battery. If the voltage is under 48V, get in contact
with CAKE.
Oil has started leaking from the fork
This can happen if the bike is stored for too long without being ridden. When
the suspension is static for too long, the gasket in-between the moving pipes
can dry out. If this happens, wipe the oil off, test the suspension to see if it
works normally and see if the leaking disappears. If it doesn't, get in contact
with CAKE directly.
Theres play between the front suspension and the frame
This is due to the that the headset is not tightened properly/has become
loose. Put the bike on a stand. Start with unscrewing the 4 screws on the
upper triple clamp so they become loose (don't unscrew completely). Push
the lower triple clamp upwards so the head tube gets full contact with the
frame. Loosen the headset bolt just a bit before tightening it hard. Tighten the
screws on the upper triple clamp and test the suspension to see if the play is
still there. Repeat if necessary. Get in contact with CAKE if the issue doesn't
resolve after the actions above.

5.7 Tools

To properly maintain and to keep your Kalk& in mint condition, we always
recommend you to use quality tools and to handle the bike with care. If you
need maintenance help, please get in touch with someone who has the
proper experience.
For the Kalk&, CAKE recommends you to buy and use the following tools
• Hex keys in mm, 1-10 mm
• Screwdriver
• Torx keys, T7-T45
• Rubber hammer
• Wrench kit in mm
• Tire iron
• Pressurized air pump