Page 2
• Remove straps • Unscrew the 6 screws in the bottom of the box...
Page 3
• With assistance, lift and remove the upper part of the box • Carefully remove the wrapping...
Page 4
Kalk OR • Unscrew the 4 screws on the stem • Place the handlebar and stem in the correct position and tighten the four screws (10 Nm) Same gap distance...
Page 5
Kalk & • Place the handlebar and stem in the correct position and tighten the four screws (10 Nm) Same gap distance...
Page 6
Kalk & • Place display on top of stem and add two screws with washers and tighten (2Nm)
Page 7
• Remove the screws holding the fork in position • Remove all straps on the Kalk ...
Page 8
• With assistance, rotate the Kalk 90 degrees on the stool • Make sure to hold the rear wheel in the air while mounting the front wheel during next steps...
Page 9
• Remove the front axle • Remove the break wedge on the calipers...
Page 10
• Place the wheel spacers in the correct position (the side with a step pointing into the hub) • Put the front wheel in place and insert the axle...
Page 11
• Insert and tighten the axle (50nm) • Tighten the 4 clamping screws (10Nm)
Page 12
Kalk & • Clean surface before assembly • Mount amber side reflector...
Page 13
Kalk & • Clean surface before assembly • Mount red side reflector (US market only)