Synthes SYNMESH Surgical Technique page 15

Surgical Technique
4. Cut mesh (optional)
If necessary, use the SYNMESH Cutter (397.091) to trim
the mesh to the appropriate height.
a. Mesh, round, B 10 mm and 12 mm
Make diagonal cuts.
b. Mesh, round, B 15 mm and all oblong meshes
Make diagonal or horizontal cuts.
To determine if the tabs of the mesh need to be adjust-
ed with the Universal Bending Pliers (391.963) line up
the desired end rings with the mesh and adjust tabs as
necessary.
Note: If an end ring with locking screw is used, the
mesh has to be cut on the horizontal.
SYNMESH™ Surgical Technique DePuy Synthes 13