Removing And Replacing Disc From/ In Cartridge Or Caddy - Hitachi DZ-MV270A Instruction Manual

Hide thumbs Also See for DZ-MV270A:
Table of Contents

Advertisement

Note:
Most generally
available
8 cm discs can be
removed
from cartridges
or caddies
if they are for
video
cameras;
However,
before
removing
disc
from cartridge
or caddy,
read the instruction
sheer
provided
with the disc or consult
the disc maker
Take care
with tile
following
when
handling
the
removed
disc:
• Be sure not to touch
disc surfaces
• Be careful
not to drop
the
disc removed
from
cartridge
or caddy
• Be sure not to bend
the disc
• Do not leave
the disc outside
the cartridge
or
caddy
• Do not subject
the disc to heat
• Do not write on disc with a ball-point
pen or pen-
cil (With one-side
recordable
disc, writing
on the
label surface
is possible with a pen that does not
scratch
the surface
No writing of any kind is pos-
sible on both-side
recordable
disc)
• Be sure not to wipe
disc surfaces
with
thinneL
water
or anti-static
agent
Use dry, soft cloth
to lightly wipe
off dust or dirt
that adheres
to the
disc
Never use solvents
to
clean
the disc
Note:
If the
disc
is removed
from
cartridge
or
caddy
and
the
data
stored
by this DVD video
camera/recorder
is rewritten
on devices
other
than
this DVD video
camera/recorder,
recording
or playback
may not be normal,
or Disc Naviga-
tion may not operate
normally,
when the disc re-
placed
in cartridge
or caddy
is used on this DVD
video
camera/recorder
again
Note:
The cartridge
or caddy
protects
the sur-
faces
of disc
on which
high-density
recording
is
possible
Once removed
from cartridge
or caddy,
the disc can be i_placed
in the cartridge
or caddy
and
used with
this DVD video
camera/recorder
but be sure to observe
the following:
• Before
replacing
the disc in cartridge
or caddy,
make
sure that disc surfaces
are not scratched,
and that no dirt or fingerprint
adheres
to them
• Do not record,
eclit or delete
on the disc when
scratches,
dirt or fingerprints
cannot
be removed
even if disc surface
is cleaned
°When
replacing
the DVD-RAM
disc in cartridge,
insert it until a click
is heard
Be caref\fl
not
to allow
condensation.
To store
disc
cartridge
or caddy,
insert
in plastic
case
provided.
Do not place
the disc cartridge
or caddy
in the fol
lowing
places:
Where
exposed
to direct
sunlight
fur" a long
time.
Where
the humidity
is high,
or in dusty
place.
Where
exposed
to heat
fl'om
heater,
etc.
Where
there
may
be condensation.
• About Stored Data
If you handle
or" use the disc incorrectly,
the re
corded data may be lost. Hitachi cannot be respon
sible for damages
fl'om loss of recorded
data.
Removing
and Replacing
Disc from/in
Cartridge
or Caddy
The DVD RAM disc used with this DVD video
camera/recorder
can be removed
Dora the cartridge
or"
caddy and used with DVD RAM drives. DVD players
and DVD recorders
that are compatible
with 8 cm
DVD RAM discs. The finalized
DVD R disc can also be removed
fl'om the cartridge
or caddy and used
with DVD players
and DVD recorders
that are compatible
fur 8 cm DVD R discs. ReDr to the disc in
struction
sheet fur details
on how to remove
disc fl'om cartridge
or"caddy.
Perform
the following
to remove the disc:
• With disc packed
in cartridge
Removing
the disc
1
Release
the lock pins of cartridge.
The two lock pins
are at the bottom
left corners
of sides
A and B.
Use a fine tipped
pen to slide the lock pin in the
direction
of arrow @, and then turn it in the di
rection of arrow @ to release
it.
_ While
the release levers from both sides
pnshing
inward,
hold the center of disc tray and pull it
out to the front.
24

Advertisement

Table of Contents
loading

Table of Contents