Table of Contents
Advertisement
Cautions
When
Using
Handle
the liquid
crystal
display
(LCD) with
care:
•
The LCD is a very delicate
display
device:
Do
not press
its surface
with
any force, hit it. or
puncture
it with a sharp object.
•
If you push the LCD surfhce, unevenness
in file
display may occtm If unevenness
does not disap
pear soon. turn tile DVD video camera/recorder
off; wait for a while, and then turn it on again.
•
Do not place the DVD video
camera/recorder
with tile open LCD screen down.
•
Close the LCD monitor when not using the DVD
video camera/recorder:
•
Do not hold by tile LCD monitor
as this could
cause a mall\ruction.
•
Open tile LCD monitor
by 900 hefore changing
its direction.
If you attempt
to invert
its direc
tion before opening
it completely,
it could cause
a mall\ruction.
•
Do not disassemhle
tile LCD monitor
as this
might cause a mall\ruction.
•
When opening
the LCD monitor, he caref\fl that
no water droplets
adhere to the monitor
screen
and that no water or dust enters the DVD video
camera/recorder
as it could cause a mall\ruction.
Liquid
Crystal
Display
and viewfinder:
•
The LCD screen and viewfinder
will he slightly
dimmer
than usual when
tile DVD video
cam
era/recorder
is at low temperature,
as in cold
areas, or immediately
after power is ttu'ned on.
The normal hrightness
will he restored when the
temperature
inside tile DVD video
camera/re
corder rises.
Hold the DVD video camera/recorder
correctly:
• Do not hold the viewfinder or LCD monitor
when lifting tile DVD video camera/recorder:
The viewfinder or LCD monitor may hecome
detached and the DVD video camera/recorder
could falh
Also. do not grasp the top of DVD video cam
era/recorder
when lifting it: It could easily be
dropped.
Do not subject the DVD video camera/
recorder to impact:
• This DVD video camera/recorder
is a precision
machine: Take great cam that you do not strike
it against a hard object or allow it to fidl.
• Do not use the DVD video camera/recorder
on
a tripod in a place where it is subject to severe
vibrations or impact.
No
sand
or dust[
•
Fine
sand
or dust
entering
tile DVD
video
ram
era/recorder
or AC
adapter
could
cause
it to
malfunction.
No water
or oil!
•
Water or oil entering
tile DVD video
camera/
recorder
or AC adapter
could cause a short cir
cuit or other malfunctions.
Heat on surface
of product:
• The surface of the DVD video camera/recorder
will he slightly warm, hut this does not indicate
a fhult. Be cmef\fl when touching the bottom of
the DVD video camera/recorder,
since it will he
hot.
Be careful
of ambient
temperature:
•
t Jsing the DVD video camera/recorder
in a place
where the temperattu'e
is over 104 °F (40 °C) or
under
32 °F (0 °C) will not allow it to make nor
real recording/playback.
•
When using
the DVD video
camera/recorder
connected
to PC. operate
it at room temperature.
If you
use the DVD video
camera/recorder
where the temperature
is high fur an extended
period of time, it will overheat
and may not op
erate normally.
•
Do not leave the DVD video
camera/recorder
in a closed vehicle where the temperature
is very
high for a long time: This could cause malftmc
tions.
Do not point
directly
at the sun:
•
If'direct
sunlight
strikes
the lens or viewfinder_
the DVD video camera/recorder
could malfnnc
tion or burn in CCD or viewfinder.
•
Do not leave the DVD video
camera/recorder
with the LCD screen exposed
to direct sunlig
This could cause malfnnctions.
19
Advertisement
Table of Contents
