Honeywell 7561-PSDS User Manual page 25

MODEL 7561-PSDS
PORTABLE SENSOR DISPLAY – STRAIN BRIDGE
|-TEDS u
|-TABLE NAME u
| |
| |-TEDS STD
| |-TEDS CAL1
| |-TEDS CAL2
| |-TEDS CAL3
| |-TEDS CAL4
| |-TEDS CAL5
|-SELECT TEDS TABLE u
| |
| |-—TEDS STD
| |-—TEDS CAL1
| |-—TEDS CAL2
| |-—TEDS CAL3
| |-—TEDS CAL4
| |-—TEDS CAL5
|-TEDS MODE u
| |
| |-—ENABLED (TEDS)
| |-—DISABLED (PSD)
|-TEDS UNIT u
|
|
|
|-—TEDS UNITS
|-—CUSTOM UNITS
Only available if a TEDS device is attached
Displays and edits the global name to give each TEDS Calibration
Table. This applies to all TEDS devices
Select a Calibration Table item to display and edit its text
description
Some Calibration Tables may not be available
Only available when an active TEDS device is attached. Select
which of the Calibration Tables held in the TEDS device to use
Select TEDS Calibration Table 1
Select TEDS Calibration Table 2
Select TEDS Calibration Table 3
Select TEDS Calibration Table 4
Select TEDS Calibration Table 5
Select TEDS Calibration Table 6
Select whether a TEDS device is enabled/active or disabled/
inactive
Enable TEDS support on the connected device
Disable TEDS support on the connected device
Allows the user to optionally override the units held in TEDS and
instead use the first of the custom units available in the Toolkit.
This will also allow unit conversion to selectable, using up to three
of the remaining custom units slots
Use the units specified in the TEDS device
Use the first custom units item instead of the TEDS units
Model 7561-PSDS User Manual |
Issue A
008-0752-00
sps.honeywell.com/ast | 25