User Operation; Keypad - Honeywell 7561-PSDS User Manual

MODEL 7561-PSDS
PORTABLE SENSOR DISPLAY – STRAIN BRIDGE

User Operation

Keypad

The keypad has both fixed and configurable functionality. It changes depending on
what is display by the LCD. The handheld can optionally sound a beep when keys are
pressed.
Figure 4. Keypad
TABLE 3. KEYPAD FUNCTIONS
Key Function
The top right key doubles as the power key. Hold it
for approximately two seconds to turn the hand-
held on or off
The three keys along the top of the keypad are
soft keys and relate to the three descriptions
shown directly above them on the LCD display.
The action of these keys will depend on what is
currently being viewed
The navigation keys are used for various purposes
such as selecting the current calibration range,
selecting the current display, navigating the
menu system, or editing string and numeric
values.
The OK key is used to open the menu (If that has
been allowed in the configuration) and to select
menu items and complete editing sessions.
Further in this document, how to use the keys to
navigate the menu system will be explained.
When not in a menu, the Up/Down keys can
perform one of a few user-definable functions,
but the default is to cycle through all available
calibration ranges.
If a TEDS device is attached, these keys will cycle
through any valid Calibration Tables held in the
device. If there is no TEDS device (or manual
override for that particular TEDS device has
been set), the keys will cycle through the internal
device Calibration Ranges.
In both the menu and the toolkit, the user may
also select an action for a long press. A long press
is when the key is held down for over a second
before being released.
Model 7561-PSDS User Manual |
Issue A
008-0752-00
sps.honeywell.com/ast | 13