Table of Contents
Advertisement
In most displays, the Program number is shown. The display of
the M-G364 is able to show either the Program number or the
Bank number — not both simultaneously.
001
O06
607
COB
Program number
@ Selecting a Capital Sound
Press Value «@
or B»
to select the desired sound or drum set.
The display will indicate the Program number.
@ Selecting a Variation Sound
Simultaneously press both Value ~@
and
B»
to enter the
mode for selecting Variation sounds. The display will show the
Bank number and a "." (dot)
Press Value =<
or B
to select the desired Variation sound.
To exit the Variation Select mode and return to the normal
Program number display, simultaneously press both the Value
~<@ and B
buttons.
* Tf the Part is a Drum Part, pressing the Variation button will
not cause the Drum Set to change. This is because Drum Sets
do not have variations.
Some Bank numbers are discontinuous.
In modes where
Patches are displayed, the following symbols
will be displayed to tell you what type of sound is currently
selected.
fle Variation Sounds
& Monitoring a Part...
After pressing the Monitor button to light up the indicator, only
one Part will be heard at a time, with all other Parts muted.
During ensemble play with a sequencer, it can sometimes be
hard to focus on listening to what individual Parts are playing.
At such times, you can activate the Monitor button (turn on its
indicator) and then switch through the Parts to listen to what is
being played by each of them.
I Changing Parameter Settings
& Selecting a Parameter; Method 1 .......sccccsseeseoee
You can make changes to the various Parameters printed on the
right-hand side of the unit's front panel,
In the example below, the Key Shift Parameter is selected.
Part Param1
o
[Level
| Pan
Reverb
[Chorus
Part Param2
e
Key Shift [Detune
P Assign
Master
o
[Tune _ [Deve
ID | Reverb
[Chorus
MIDI Rx
oO
[vol & Hold [Pro
Chg [Bank Self Sys Ex
ie}
e
oO
°
S
0606 0
Select
1
Bee
Bea
may
B Selecting a Parameter; Method 2 ........ccceesseeees
The M-GS64 has five parameter matrices, as shawn in the dia-
gram. You can select a parameter from a matrix and then modify
its setting.
@ Selecting a Parameter Matrix
While pressing the Select button, press a function button to select
a parameter matrix.
The function button whose indicator is flashing shows which
matrix is selected.
Matrix 0 (Basic Menu)
Pbevel_[
Pan
[Reverb
[Chorus
I Rx Ch
[key Shift [Detune
LAssign
Part Param1
©
Part Param2
0
Master
o
|_Tune _ pDevice ID Reverb
[Chorus
MIDI
Rx
©
Pol
& Hold FProg Chg [Bank Sel [Sys Ex
°
ie]
°
°
O
Select
F4
F2
F3
F4
To select Matrix 1 (Part parameters)
Hold down the Select button and press the F1 button.
The Fl indicator will blink,
Advertisement
Table of Contents
