Battery Case Removal; Pc Board C Removal; Further Disassembly - Vivitar 283 Service Manual

•
Automatic Electronic Flash
Model 283
K. Detach battery terminals from battery case, and lift battery case out of body case LA. Fig. 3-9.
L. Remove shoe attaching plate and associated piece of plastic insulation. Fig. 3-9.
Sensor Receptacle
Insulation
Shoe Attaching
Plate - - - - -- .:::
Figure 3-9. Battery Case Removal
Battery
Case
M. Remove main capacitor C1 by carefully breaking glue band and lifting out of case as shown. Fig. 3-10.
N.
Slide PC board 8 out of grooves. PC board C can now be
lifted out of case.
PC Board B
PC Board C
Figure 3-10. PC Board Band C Removal
0. Detach BCC (bounce compensator circuit) switch by removing two screws. Slide PC-1 receptacle up
and out of compartment. Lay body case LA aside. Fig. 3-11.
P. To further disassemble PC boards and components, desolder leads as required.
BCC Switch
- - - - - - - PC-1
Receptacle
Remove
Figure 3-11. Further Disassembly
Vivitar 37460598 (11/80)
11