Troubleshooting - Ego Power+ CS2000E Operator's Manual

TROUBLESHOOTING

PROBLEM
Motor does not start.
Chainsaw stops running
.
during working
Motor runs, but chain does
not rotate.
Chain brake does not
engage.
CAUSE
◾
The battery pack is not attached to
the chainsaw.
◾
No electrical contact between the
saw and battery pack.
◾
The battery pack is depleted.
◾
The battery pack or chainsaw is
too hot.
◾
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
The chainsaw is overloaded.
◾
The battery pack or chainsaw is
too hot.
◾
Saw chain is bound in the wood.
◾
Chain does not engage drive
sprocket.
◾
Debris preventing full movement of
the chain-kickback brake paddle.
◾
Possible chain brake malfunction.
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS2000E
SOLUTION
◾
Attach the battery pack to the
chainsaw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or chainsaw
to cool until the temperature drops
below 67°C.
◾
Pull the chain-kickback brake paddle
backward toward the front handle,
arriving at the operating position.
◾
Press the saw chain against the
wood, move the chainsaw back and
forth to discharge the debris.
◾
Remove battery pack, then remove
side cover and clean out debris.
◾
Decrease the load.
◾
Decrease the load. Allow the battery
pack or chainsaw to cool until the
temperature drops below 67°C.
◾
Release the trigger switch; remove
the saw chain and guide bar from the
wood, then restart the chainsaw.
◾
Reinstall the chain, ensuring that
the drive links on the chain are fully
seated on the sprocket.
◾
Clean debris from the external chain
brake mechanism.
◾
Contact EGO Customer Service for
repair.
19