Ego Power+ CS2000E Operator's Manual page 20

PROBLEM
Chainsaw does not cut
properly.
Chain becomes loose or
drops off the guide bar
during normal use.
20
56 VOLT LITHIUM-ION CORDLESS CHAIN SAW — CS2000E
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched chain.
◾
Chain not in bar groove.
◾
The chain will become loose as the
temperature of the chain increases
during normal saw operation.
◾
Chain does not engage drive
sprocket.
SOLUTION
◾
Readjust the chain tension, following
the section: "ADJUSTING THE CHAIN
TENSION".
◾
Sharpen the chain.
◾
Reinstall the saw chain, following the
section "ASSEMBLING/REPLACING
THE BAR AND CHAIN".
◾
Replace the chain, following the
section: "ASSEMBLING/REPLACING
THE BAR AND CHAIN".
◾
Check the oil level. Refill the oil
tank and choose a higher oil supply
volume if necessary.
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING
THE BAR AND CHAIN".
◾
Tighten the chain tension, following
the section "ADJUSTING THE CHAIN
TENSION".
◾
Reinstall the saw chain, following the
section: "ASSEMBLING/REPLACING
THE BAR AND CHAIN".