Troubleshooting - Ego Power+ CS1610E Manual

TROUBLESHOOTING

EN
WARNING:
maintenance on the saw chain.
Always remove the battery pack when servicing or transporting the chain saw.
PROBLEM
Motor does not start.
Chain saw stops
running during
working.
Motor runs, but
chain does not
rotate.
Chain brake does
not engage.
23
CORDLESS CHAIN SAW — CS1610E
Always protect your hands by wearing heavy gloves when performing any
◾
CAUSE
◾
The battery pack is not attached
to the chain saw.
◾
There is no electrical contact
between the saw and battery.
◾
The battery pack is depleted.
The battery pack or chain saw
◾
is too hot.
Chain brake is engaged.
◾
Debris in bar groove.
◾
Debris in side cover.
◾
◾
The chain saw is overloaded.
The battery pack or chain saw
◾
is too hot.
Saw chain is bound in the wood.
◾
Chain does not engage drive
sprocket.
◾
Debris preventing full movement
◾
of the chain kickback brake
handle.
Possible chain brake malfunction.
◾
SOLUTION
Attach the battery pack to the chain
◾
saw.
Remove battery, check
◾
contacts and reinstall the
battery pack.
◾
Charge the battery pack.
Allow the battery pack or chain saw
to cool until the temperature drops
◾
below 67°C.
Pull the chain-kickback brake
handle backwardtoward the front
◾
handle,arriving at the operating
position.
Press the saw chain against the
wood, move the chain saw back
◾
and forth to discharge the
debris.
Remove battery pack, then
◾
remove side cover and clean out
◾
debris.
Decrease the load.
Decrease the load. Allow the
battery pack or chain saw to cool
◾
until the temperature drops below
67°C.
Release the variable-speed trigger
switch; remove the saw chain and
◾
guide bar from the wood, then
restart the chain saw.
Reinstall the chain, ensuring that
the drive links on the chain are fully
◾
seated on the sprocket.
◾
Cleandebris from the external chain brake
mechanism.
Contact EGO Customer Service for
repair.