Onkyo TX-NR906 Service Manual page 168

FIRMWARE UPDATE -6
Preparation for Update (Network)
Hardware and Software
1. Personal computer(PC) with USB slot (only for preparation)
2. USB memory
3. Writing soft: the target version of "firmware.dat"
Preparation
1. Delete any folders and files in a USB memory.
2. Store "firmware.dat" in the USB memory.
Network Update Procedure
1. Power on TX-NR906/TX-NA906/DTR-9.9.
2. Select [NET/USB], and see "Startup.." shown for a while on Front Panel and disappear.
3. Press [NET/USB] button repeatedly until " USB <No storage> " is shown.
4. Load the USB memory into USB slot on Front Panel.
Make sure that the connected USB memory is detected and the volume name of the USB memory is shown.
<e.g.>
5. Press and hold down [DISPLAY] button and then press [ON/STANDBY] button to show Main FW version
when the unit is powered on.
<e.g.>
6. Press [Tone -] button several times while the Main Microprocessor version is displayed. Then, Net user version will be displayed.
<e.g.>
7. Press [DISPLAY] button while Net user version is displayed. Then, the following message will appear.
8. Display "SH4APL" by using the cursors on the front panel.
SERVER
S t a r t u p.. .
U S B 0 / 0
<N o s to ra g e >
U S B 1 / 1
o U S B s to ra g e
M a i n :
9 1 .0 1 /0 8 8 0 1 A
N e t u s r :
0 8 0 4 0 2 /1 9 0 9 2 8
N E T F /W u p d a t e
R DV- 0 0 :0 0 0 0 0 0 0
N E T F /W u p d a t e
S H 4 A P L :- 8 7 0 2 a 0
www.audiodna.sk
TUNING
PRESET
Cursors on Front Panel of TX-NR906
TUNING
TX-NR906/NA906