Watchguard V10 User Manual page 222

CHAPTER 8: About Security Policies
2
In the Tenant Name and Description fields, type a
name and brief description for the tenant. The
Description field is optional.
3
In hte Public Interface IP and Public Interface Mask
fields, type the IP address and netmask of the public
interface, or select the Use Default checkbox to use the
default IP address and netmask.
The default address and netmask is the IP address and netmask
of the Public port (Interface 1).
4
Click either VLAN or User Domain.
The dialog box refreshes and fields are displayed relevant to the
VLAN or User Domain option enabled.
To configure the VLAN option:
1
Type the pre-assigned number (between 1 and 4094)
that will identify this VLAN traffic in the VLAN ID
field.
2
Select the interface that connects to the VLAN network
from the Interface drop-down list.
3 In the VLAN IP field, type the IP address that is
assigned to the interface on the specified VLAN
network.
This IP address can also be used as a default gateway address for
the devices on the specified VLAN network.
4
In the VLAN Mask field, type the mask associated
with the VLAN IP address.
5
In the Gateway field, type the gateway IP address for
traffic destined for the VLAN tenant.
If the destination of the packets that are forwarded to this VLAN
tenant is not on the same subnet (as defined by VLAN IP and
netmask), these packets will be forwarded to the default gateway.
The gateway IP address should be in the same subnet as the
VLAN IP . If you leave this field empty, routing will occur based
on the routing table.
6
Click Done.
7 Repeat this process as needed to create additional
VLAN tenant entries.
To configure the User Domain option:
190 Vcontroller