Introduction
1.2.3.7 Specifications
This section provides the general information
about this equipment. Some information may
change as design modification.
1.3 Your SANY Equipment
1.3.1 Equipment directions
(A) Front
(B) Back
(C) Left
(D) Right
1.3.2 Breaking in a new equipment
Your equipment has been well adjusted
and tested before delivery. However, initial
o p e r a t i o n o n t h e e q u i p m e n t i n s e v e r e
conditions will seriously affect the performance
or reduce the service life of the equipment.
Thus SANY recommends you to perform 100-
hour test run before putting the equipment into
production use.
During the break-in period:
Let the equipment warm up prior to any
•
operation.
Avoid operating or running the equipment
•
at a high speed in overload working
conditions.
Avoid sudden starting, rapid movement or
•
abrupt stop of the equipment.
Cool down the equipment system at the
•
end of every working day.
1-4
Safety, Operation & Maintenance Manual - January 2019
SSR150 Series Single Drum Roller
C
Fig.1-2
A
D
B