Hydraulic Oil - Fayat Group BOMAG BF 700 C-2 Service Manual

General – Fuels and lubricants
1.3.3.2 Topping up coolant
1.3.3.3 Replacing coolant

1.3.4 Hydraulic oil

1.3.4.1 Mineral oil based hydraulic oil
20
Leave the coolant in the system all year around. This applies also
for countries with high ambient temperatures.
Check the anti-corrosion/anti-freeze concentration in the coolant
every six months.
Use only approved anti-corrosion/anti-freeze agents.
NOTICE!
Danger of engine damage!
Use only prepared coolant with 50 % by volume
anti-corrosion/anti-freeze as per sheet 325.5 or
326.5 to replenish the system.
Information on operating fluids tested by Mer-
cedes-Benz and approved for your engine can be
found on the internet under:
http://bevo.mercedes-benz.com/
Only fill in anti-corrosion/anti-freeze agent of the
same quality range.
In case of coolant loss, do not fill only with water, but add also the
appropriate proportion of approved anti-corrosion/anti-freeze
agent.
n
every 3 years
When renewing the coolant you must make sure that the coolant
contains 50 Vol.-% by weight of anti-corrosion/anti-freeze agent.
This corresponds with a frost protection down to -37 °C (-35 °F).
Do not exceed a proportion of 55 Vol.-% (frost protection down to
approx. -45 °C (-49 °F)). Otherwise heat discharge and anti-freeze
properties will be adversely affected.
The water in the coolant must meet certain requirements, which
are most frequently met by drinking water. If the water quality is not
sufficient, you should have water specially prepared. Follow the
operating fluids instructions according to sheet 310.1 issued by
Mercedes-Benz.
The hydraulic system is operated with hydraulic oil HV 46 (ISO)
with a kinematic viscosity of 46 mm
8 mm 2 /s at 100 °C (212 °F).
BF 700 C-2
/s at 40 °C (104 °F) and
2