Fayat Group BOMAG BW 190/202 AD-5 Service Manual page 27

1.2.7.2 Driving the machine
1.2.7.3 Driving on gradients and slopes
1.2.7.4 Parking the machine
Always wear the seat belt when driving.
Do not drive on bases with insufficient load bearing capacity.
Do not drive on ice and snow.
If the machine has touched high-voltage power lines:
n
do not leave the driver's stand,
n
warn others from coming close to or touching the machine,
n
if possible, drive the machine out of the danger zone,
n
have the power switched off.
Operate the machine only from the driver's stand.
Keep the cabin doors closed.
Do not adjust the driver's seat while driving.
Do not climb onto or off the machine while the machine is driving.
Do not use the machine to transport persons.
In case of unusual noises and development of smoke perform
trouble shooting to determine the cause and have the fault cor-
rected.
Match the speed to the working conditions.
Do not make extreme steering movements when driving with high
speed, danger of tipping over!
Always give way to loaded transport vehicles.
Switch the lights on if the visibility is poor.
Always keep a safe distance to excavation pit borders, embank-
ments and edges.
Refrain from any work that could adversely affect the stability of the
machine.
Always keep a sufficient distance when passing through subways,
under bridges, tunnels, electric power lines etc.
Do not drive on gradients exceeding the maximum gradability of
Ä Chapter 3 „Technical data" on page 69.
the machine
Drive extremely carefully on gradients and always directly up or
down the slope.
Soil conditions and weather influences impair the gradability of the
machine.
Wet and loose soils considerably reduce ground adhesion of the
machine on gradients and slopes. Higher risk of accident!
Park the machine on horizontal, level, firm ground.
BW 190/202 AD-5 / BW 190/202 ADO-5
General – Concerning your safety
27