Vii. Maintenance; Viii. Troubleshooting - Bindicator Pulse Point II Series Installation & Operation Manual

VII. MAINTENANCE

PREVENTATIVE MAINTENANCE
No scheduled preventative maintenance is required for the LP II Series units when properly applied and installed
correctly. There is no cleaning required for the unit before or during installation.
If the cover is removed after the unit has been in service, it is recommended to replace the gasket to prevent the
ingress of water or dust. At a minimum the gasket should be inspected for folds, cracks, and tears.

VIII. TROUBLESHOOTING

SYMPTOM
Main relay not Functioning
and Power LED is not
illuminated
The unit is not
responsive
Main relay is functioning
and Power LED is
illuminated
LVP180613 Rev. B
POSSIBLE CAUSE
No power,
Blown fuse
Electronic failure, or main
relay contacts are fused
19
www.bindicator.com
SOLUTION
Apply proper AC/DC
voltage to the board and
recheck the unit.
If power is present and
Power LED is not
illuminated, then the main
fuse is blown.
Replace electronics.
Replace electronics.