Warranty - Chicco CUSHY HUG PER GOODY XPLUS Manual

months of age.
For babies from about 0 to 3 months of age:
To assemble the product complete the steps described
below:
1. Recline the backrest completely acting on the lever locat-
ed on the backrest of the stroller and remove the comfort
kit from the shoulder straps (Fig. 1). Lift the stroller leg-
rests completely.
2. Insert both of the side paddings into the appropriate
pockets located on the back of the reducer cushion (Fig.
2). Next, position Cushy Hug on the seat and insert the
shoulder straps, crotch strap, and waist straps in the ap-
propriate slots (Fig. 2A/2B); reposition the comfort kit that
had been removed previously.
3. Fasten the Infant Positioner by inserting the buttons
found on its extremities into the two lower lateral but-
tonholes of the reducer cushion (fig. 3) and the central
button into the external elastic buttonhole located on
the perimeter of the foot area (Fig. 3A). Once assembled,
the product will appear as shown in the image (Fig. 3B).
For babies from about 3 to 6 months of age:
4. Raise the backrest into the partially-seated or seated po-
sition (Fig. 4) and install Cushy Hug as described in point
2 above.
5. Fasten the Infant Positioner by inserting the buttons
found on its extremities into the two lower lateral but-
tonholes of the reducer cushion (Fig. 5) and the central
button into the buttonhole located just below the crotch
strap slot (Fig. 5A).
In this configuration the lateral padding can be adjusted to
fit the height of the baby. Should the baby requires more
room, use the appropriate lables (Fig. 5B) to pull down the
lateral paddings until they reach a position that is ideal for
the child's comfort and guarantees support for their pos-
ture.
2. CUSHY HUG: USING THE REDUCER ALONE
In this configuration the product is suitable from 6
months of age or from the time when the baby is able
to remain seated on their own.
For extra comfort the reducer cushion can be used without
the Infant Positioner and/or the lateral padding.
6. Adjust the backrest to reach the desired position and
adapt the shoulder straps to fit the height of the baby. To
assemble the reducer cushion follow the steps described
in point 2. The side padding can be removed if they are
not needed to keep the torso contained.

WARRANTY

The product is guaranteed against any lack of conform-
ity under normal use as specified in the instructions. The
warranty shall not therefore apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of warranty on conformity defects please refer to
the specific provisions of national laws
8