Maytag MDE20PDFGW Installation Instructions Manual page 19

Accumulator Pricing
If the price is set to one coins or Gen 1 Debit Pulses, then
accumulator pricing is in effect. Cycle time can be purchased
one coin at a time up to the maximum time of 75 minutes.
Fixed Cycle With Top Off Pricing
A dryer set to offer "Top Off" capability will allow time to be
added to an existing dry cycle in increments equal to the
number of minutes of dry time per coins or Gen 1 Debit Pulses,
up to 75 minutes, regardless of the cost required to start the
dryer. No credit is given for coins or debit inputs entered when
the control is displaying 75 minutes.
Free Cycles
This is established by setting the cycle price to zero. When
this happens, "SELECT CYCLE" will appear rather than a
cycle price. Any cycle started as a free cycle will automatically
terminate when the door is opened.
DEBIT CARD READY – This dryer is debit card ready. It
will accept a variety of debit card systems, but does NOT
come with a debit card reader. Refer to the debit card reader
manufacturer for proper dryer setup. In models converted to
a Generation 1 debit card system, debit pulses represent the
equivalent of one coin (Coins or Gen 1 Debit Pulses).
Display
After the dryer has been installed and plugged in, the display
will show "0 minutes."
Single Load Models
Once the unit has been plugged in and the dryer door opened
and closed, the display will show the price.
Single Load Models
0
MINUTES
PRICE
1.50
Control Set-up Procedures
IMPORTANT: Read all instructions before operating.
The keypads along with the digital display are used to set up
the dryer controls. The display can contain 4 numbers
and/or letters and a decimal point. These are used to indicate
the set-up codes and related code values available for use in
programming the appliance.
How to Use the Buttons to Program the Controls
1. The HEAVY DUTY button is used to adjust the values
associated with set-up code. Pressing the button will
change the value by increments. Rapid adjustment is
possible by holding down the button.
2. The NORMAL button will advance through the set-up
codes. Pressing the button will advance to the next
available set-up code. Holding down the NORMAL button
will automatically advance through the set-up codes at a
rate faster than 1 per second.
3. The DELICATES button is used to select or deselect options.
Start Operating Set-up
Single Load PD Models: Insert service door key, turn, and
■
lift to remove service door.
Single Load PR Models: Once the debit card reader
■
is installed (according to the reader manufacturer's
instructions), the set up mode can be entered by inserting
a manual set-up card (supplied by the reader manufacturer)
into the card slot. if manual set-up card is not available,
manual set-up mode can be entered by removing connector
J4 on the circuit board.
The dryer is now in the set-up mode.
NOTE: This dryer is preset at the factory and does not require
any programming. However, if you want to change the settings,
follow the "Set-Up Codes" guide below.
PD Units are pre-set at the factory for fixed cycle price with
■
top off.
PR units are pre-set for free cycle operation so they can be
■
run without readers or coins.
FOR PR MODELS: The set-up codes are the same as for the
PD models except where noted.
19