Table of Contents
Advertisement
TK-2300/TK-2700 Operation Manual
6-2 Assigning Drawers for Each Clerk
CLERK
DRAWER
:
SECRET
NUMBER | "| NUMBER
1. Input the number of the drawer you want to assign (1 to 4).
2. Input a 4-digit clerk secret number (0001 to 9999) that identifies the clerk
you want to assign the drawer to. Note that you must input all four
digits of this number.
procedures described in this section.
¢ Do not use decimal point key when inputting values in this procedure.
The procedure to specify values (6-digit integers or 6-digit integers with
3-digit decimals) for actual stock quantity maintenance is explained in the
Programming Manual.
¢ Values you specify in the operations shown in this section are either
added to or subtracted from the current actual stock quantity. Do not
input a new stock quantity.
To add to the
cae
SUB TOTAL
1. Input the PLU number or Random PLU code that identifies the Long
PLU whose actual stock quantity you want to add to.
2. Input the value you want to add to the actual stock quantity of the
Long PLU you specified above. You can input a 6-digit integer in the
range of 1 to 999999 or a 9-digit fractional value in the range of 0.001 to
999999.999. The type of value you input depends on how the register is
programmed.
4. Loop here if you want to add a different value to the next sequential
PLU number.
Advertisement
Table of Contents
