Table of Contents
Advertisement
TK-2300/TK-2700 Operation Manual
1-2 Loading Paper Rolls
Receipt Paper
1.
Journal Paper
1,
Place the paper roll in its housing so that its leading edge can be pulled
up from the bottom (Fig. 1-2).
Fold the end of the paper (Fig. 1-4) and insert the paper into the paper
inlet (Fig. 1-3), and press the Receipt Feed key until approximately 20cm
of paper are fed from the outlet.
Pass the leading edge of the paper through the paper outlet in the
printer cover (Fig. 1-5), and close the cover.
Tear off the excess paper and make sure that it is feeding properly.
Place the paper roll in its housing so that its leading edge can be pulled
up from the bottom (Fig. 1-2).
Fold the end of the paper (Fig. 1-4) and insert the paper into the paper
inlet (Fig. 1-6), and press the Journal Feed key until approximately 20cm
of paper are fed from the outlet.
Lift the take-up reel, and insert the leading end of the paper into the slit
in the take-up reel (Fig. 1-7). Wind the paper two or three turns onto
the reel.
Replace the take-up reel and press the Journal Feed key to take up any
slack in the paper. Confirm that the paper is feeding properly.
AX
Correct
Incorrect
Fig 1-7.
/
Advertisement
Table of Contents
