Page 3
695 PROOFER INDEX (Continued) Section Description Document No. Page No. REPLACEMENT PARTS SECTION ELECTRICAL PANEL ------------------------------------ 0695S20009 --------------------- 8-1 Manual Controls Drawing ----------------------------------------------------------------------------------------- 8-1 Parts List --------------------------------------------------------------------------------------- Digital Control Drawing ----------------------------------------------------------------------------------------- 8-3 Parts List --------------------------------------------------------------------------------------- DOOR ASSEMBLY ---------------------------------------- 0695S20010 --------------------...
695 PROOFER SAFETY INSTRUCTIONS WARNING VARIOUS SAFETY DEVICES AND METHODS OF GUARDING HAVE BEEN PROVIDED ON THIS PROOFER. IT IS ESSENTIAL HOWEVER THAT THE PROOFER OPERATORS AND MAINTENANCE PERSONNEL OBSERVE THE FOLLOWING SAFETY PRECAUTIONS. IMPROPER INSTALLATION, MAINTENANCE, OR OPERATION COULD CAUSE SERIOUS INJURY OR DEATH.
695 PROOFER DESCRIPTION/SPECIFICATIONS Description The Proofer is a stainless steel, electric, forced air, proofer with adjustable temperature and humidity capabilities. This proofer offers consistent proofing at all rack levels due to the careful positioning of the heating and humidification systems.
Page 6
695 PROOFER Space Requirements: Figure 1.0 single: 43 1/2” Deep x 33 1/2” Wide x 40-1/2” high. (with casters) stacked oven and proofer with casters: 78” Clearance: Left side = 2”. Right side = 2” with casters. Back side = 4” to allow for water connection.
Proofer Setup Proofers may stand alone or be stacked with a Oliver oven ( oven must be on top of proofer ). For associated mounting heights for the above options see figure 3.0 on page 2-2.
695 PROOFER Electrical Connection WARNING THE PROOFER MUST BE CONNECTED TO A PROPERLY GROUNDED ELECTRICAL SOURCE OF THE SAME RATING AS THE MACHINE. FAILURE COULD RESULT IN AN ELECTRICAL SHOCK WHICH MAY CAUSE INJURY OR DEATH. WARNING ALL WIRING AND ELECTRICAL REPAIRS SHOULD BE DONE BY A QUALIFIED ELECTRICIAN.
695 PROOFER Water Connection All water connections must comply with the basic plumbing code of the Building Officials and Code Service Sanitation Manual of the Food and Drug Administration (FDA) CAUTION WATER PRESSURES GREATER THEN RECOMMENDED CAN CAUSE EXCESS WATER TO ENTER THE PROOFER CAUSING WATER TO LEAK AT THE DOOR AND ALSO CAUSE THE HUMIDITY TO DROP SEVERELY AFFECTING THE PROOF.
695 PROOFER OPERATING INSTRUCTIONS – MANUAL CONTROLS Control Panel Figure 2.0 Beginning Operation First turn the proofer on using the power switch. Set desired temperature and humidity using the chart (figure 3.0, page 4-2) as a guide. Allow several minutes for the proofer to reach desired settings.
695 PROOFER OPERATING INSTRUCTIONS – DIGITAL CONTROLS Control Panel Figure 4.0 Beginning Operation First turn the Proofer on using the power switch. Proofer will start preheating to last set temperature and humidity. (PrEH will be displayed until unit has reached temperature and RH settings then REAdy will be displayed –...
Page 13
695 PROOFER Beginning Operation (continued) Indicator LED’s show when heat and / or steam are on. Up and Down Keys The Up and Down keys are used to adjust settings (either Time, Temperature, or RH). Settings (as opposed to actual readings) are recognized on the display by 2 things: the left most triangle is lit (i.e.
Page 14
695 PROOFER Beginning Operation (continued) RH Key A normal press of this key forces the display to show the current RH reading. If the RH key is held for 2 seconds, the display will show the current RH setting. RH key, as well as Up and Down LED’s are also lit, indicating that RH setting can be changed if...
695 PROOFER TROUBLESHOOTING WARNING TROUBLE SHOOTING OF ELECTRICAL EQUIPMENT SHOULD BE PERFORMED BY QUALIFIED PERSONNEL ONLY. ELECTRICAL POTENTIAL IS GREAT ENOUGH TO CAUSE INJURY OR DEATH. WARNING NEVER ATTEMPT TO SERVICE THIS PROOFER UNTIL IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY. ALL ELECTRICAL WORK MUST BE DONE BY A QUALIFIED ELECTRICIAN.
695 PROOFER No Humidity or Proofer Reaches Humidity Slowly. • Power switch is in off position. • Humidity setting too low. • Check fan in air duct for proper operation. • Check thermostat (lower manual control) or controller (digital proofer) for proper operation.
695 PROOFER MAINTENANCE WARNING NEVER ATTEMPT TO CLEAN OR SERVICE THIS PROOFER UNTIL IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND IS COOL TO THE TOUCH. NOTE REMEMBER A CLEAN PROOFER WILL LAST LONGER AND WORK BETTER. Cleaning The outside of the proofer should be cleaned daily by wiping it with a clean damp cloth or by using any suitable stainless steel cleaner.
695 PROOFER Electrical Component Replacement WARNING NEVER ATTEMPT TO SERVICE THIS PROOFER UNTIL IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY. ALL ELECTRICAL WORK MUST BE DONE BY A QUALIFIED ELECTRICIAN. • Remove the front side panel which is located on the control side.
Thermostat – Bulb and Cap (85-230 deg.) 5759-2050 Knob – Instrument 5749-8024 Relay-Power SPDT, 360w Specific to Digital Proofer 5712-4025 Overlay – Proofer Control 5749-8027 Relay – DPST 20A 120V Coil 5749-8024 Relay-Power SPDT, 360w For Service Parts Call Oliver Products @ 800-253-3893 Revised 4-5-04 0695S20008...
Page 25
695 PROOFER DOOR ASSEMBLY PARTS LIST ITEM NO PART DESCRIPTION PART NUMBER FRAME-REAR DOOR 0695-0011 GASKET-OVEN DOOR 6904-6062 PLATE-MAGNET 0695-0023 PANEL-LEXAN 0695-0013 FRAME-FRONT DOOR 0695-0012-001 HANDLE-STST TUBULAR 5908-5116 HINGE-STST SLIP 0695-0024 FOR SERVICE PARTS CALL OLIVER PRODUCTS @ 800-253-3893 0695S20010...
Page 27
SEE WATER SYSTEM LIST (PG. 11-2) SEE COVERS/RACKS LIST (PG. 12-2) SEE ELECTRICAL PANEL LIST (PG. 8-2) SEE ELECTRICAL PANEL LIST (PG. 8-2) SEE ELECTRICAL PANEL LIST (PG. 8-2) FOR SERVICE PARTS CALL OLIVER PRODUCTS @ 800-253-3893 Revised 4-5-04 0695S20011 10-2...
Page 28
695 PROOFER WATER SYSTEM ASSEMBLY 0695S20012 11-1...
Page 29
VALVE-WATER SOLENOID 5148-6770 BRACKET-WATER VALVE 0695-0020 210* FITTING-FEMALE CONNECTOR 5115-6231 218* VALVE-NEEDLE 5148-5784 TRAY-WATER 0695-0014 COVER-HEATER 0695-0015 HEATER-TUBULAR WATER 5730-2657 CLAMP 0695-0016 PLATE-HEATER INTERFACE 0695-0068 * ITEMS NOT SHOWN IN ILLUSTRATION. FOR SERVICE PARTS CALL OLIVER PRODUCTS @ 800-253-3893 0695S20012 11-2...
Page 34
WARRANTY PARTS Oliver Packaging & Equipment Company warrants that if any part of the equipment (other than a part not manufactured by Oliver Packaging & Equipment ) proves to be defective (as defined below) within one year after shipment, and if Buyer returns the defective part to Oliver Packaging & Equipment within one year, Freight Prepaid to Oliver Packaging &...
Page 35
THIS PAGE WAS INTENTIONALLY LEFT BLANK. GEN020319...
Page 36
4. The service dealer will then complete an invoice and send it to the Parts and Service Department at Oliver Packaging & Equipment Company. 5. The Parts and Service Manager of Oliver Packaging and Equipment Company will review the invoice and returned parts, if applicable, and approve for payment.
Page 37
THIS PAGE WAS INTENTIONALLY LEFT BLANK. GEN020319...
Page 38
This policy applies to all parts returned to the factory whether for warranted credit, replacement, repair or re-stocking. Oliver Packaging and Equipment Company requires that the customer obtain a Return Material Authorization (RMA) number before returning any part. This number should appear on the shipping label and inside the shipping carton as well.