Sony RDR-HX900 Operating Instructions Manual page 82

10Select
"Start," and press ENTER.
The recorder starts recording the tape contents
as programmed.
• If the recording does not fit due to the
dubbing mode you selected, the display asks
if you want to continue. To change the
dubbing mode, select "Reset" and repeat
from step 9. To have the recorder adjust the
dubbing mode, select "Auto Dub Mode."
• If there is not enough disc space even after
changing the dubbing mode, the display
asks if you want to record halfway. To
continue, select "OK."
To stop during recording
Open the remote's cover and press • RE( STOP.
Note that it may take a few seconds IBr the
recorder to stop recording.
• The disc may not be recorded as programmed iffl:e
tape's time code is not sequential or there are blanks
between the recordings on the tape. In this case, see
"Recording Froln a VCR or Similar Device" (page 53).
• The strut and end points of a program may be difl'e:ent
from what you have set if the source DViDigital8
tb:mat tape is in any of the tbllowing conditions:
Recording mode was changed during the recording.
Thee is a blank space in the recorded po:tion of the
tape.
• If you set the beginning of file tape as the IN point and
the end point a s the OUT point, the IN and OUT points
may change slightly &:ring dubbing.
• YOll cannot set a scene to
be
sholter than
one
second.
RDR-HX900
2-!87-189-11(2)
82