Sony DCR-SC100 Operating Instructions Manual page 88

Trouble check
Operation
Symptom
Cause and/or corrective actions
The tape does not move when a tape
transport button is pressed.
•
•
The POWER switch is set to CAMERA or OFF.
4 Set it to VTR. (p. 23)
The tape has run out.
4 Rewind the tape or use a new one. (p. 23)
No sound or orUy a low sound is heard
when playing back a tape.
•
•
The volume is turned to the minimum.
4 Press VOLUME +. (p. 23)
AUDIO MIX is set to ST2 side in the menu system.
4 Adjust AUDIO MIX in the menu system (p. 30).
The new sound added to the recorded
tape is not heard.
• AUDIO MIX is set to ST1 side in the menu system.
4 Adjust AUDIO MIX in the menu system (p. 30).
The SteadyShot function does not activate.
• STEADYSHOT is set to OFF in the menu system.
4 Set it to ON. (p. 46)
Recording stops at once. • The POWER switch is set to PHOTO.
4 Set it to CAMERA.
Recording stops in a few seconds.
• The START/STOP MODE switch is set to
5SEC
or
± .
4 Set it to ^ . (p. 18)
The autofocus function does not activate.
• Focus is fixed.
4 Release the focus lock function, (p. 19)
The fader function does not work. • The START/STOP MODE switch is set to
5SEC or .
4 Set it to ^ . (p. 18)
The title is not displayed. • TITLE DSPL is set to OFF in the menu system.
4 Set it to ON in the menu system, (p. 67)
The title is not recorded. •
•
•
•
•
The tape has no cassette memory.
-» Use a tape with cassette memory, (p. 66)
The cassette memory is full.
-> Erase another title, (p. 68)
The tape is set to prevent accidental erasure.
-> Slide the protect tab so that red portion is not visible.
(P- I')
The fader function is working.
•*
Wait until the fader function is finished, (p. 36)
Nothing is recorded in that position on the tape.
-> Superimpose the title to the recorded position, (p. 66)
The cassette label is not recorded.
• The tape has no cassette memory.
-> Use a tape with cassette memory, (p. 71)
•
•
The cassette memory is full.
4 Erase some titles, (p. 68)
The tape is set to prevent accidental erasure.
4 Slide the protect tab so that red portion is not visible.
(P ID
Displaying the recorded date, date search
function does not work.
•
•
The tape has no cassette memory.
4 Use a tape with cassette memory, (p. 51)
CM SEARCH is set to OFF in the menu system.
4 Set it to ON. (p. 30)
90