Table of Contents
Advertisement
1. Mount the device
Using the holes on the back of the device, mount it in
a safe place away from water and vapors.
Connect the device to the power supply.
Using the power cord
included in the set, connect the device to the
mains socket. Insert the power cord into a tightly
fitting socket, make sure that the cord is not loose.
2. Install the temperature sensor in the water.
ATTENTION! The sensor must be in a safe place with a constant temperature.
Place it away from water surfaces and heat sources such as heaters.
3. Connect the heating and cooling device as marked.
Manual Thermo control
I. Assembly of the device
Reef Factory 2023
©
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Thermo control and is the answer not in the manual?