Reef Factory Thermo control User Manual page 11

Hide thumbs Also See for Thermo control:
Table of Contents

Advertisement

Immerse the sensor in water of known temperature. Wait 60 seconds,
then press "OK".
In the next step, enter the correct water temperature value. Then
accept by clicking "OK".
The calibration process has been successfully completed.
ATTENTION! After calibration, remember to put the
temperature sensor back into the aquarium water
and connect the heating and cooling devices.
Manual Thermo control
After the calibration process, the Thermo control device will indicate
the corrected temperature in the menu, and when you press the
"SETTINGS" button again, information about the value of the
measurement difference after calibration will additionally appear. A
value of -0.2 means that the temperature value you entered is 0.2 units
lower than the value measured before calibration.
Reef Factory 2023
©
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Thermo control and is the answer not in the manual?

Subscribe to Our Youtube Channel

Related Products for Reef Factory Thermo control

This manual is also suitable for:

Rftc01

Table of Contents