Operation - PCE Instruments PCE-T 420 User Manual

7.2

Operation

Pressing the REC key opens the data logger info window. The current status of the data logger,
all set parameters and the information that the data logger is started by holding down the REC
key are displayed there.
Fig. 14 Data logger info
Depending on the start condition, the data logger starts automatically when set start time has
been reached.
A measurement in progress is indicated by the message REC in the upper left corner of the
display and a flashing red circle.
Fig. 15 Data logger info (ongoing measurement)
The measured values can be observed in the same way as in regular measuring mode. To do
this, the data logger info window can be exited with the BACK key.
Depending on the stop condition set, the data logger stops either automatically after reaching the
stop time or after the desired duration or after holding down the REC key again. Even if a time or
duration has been set as the stop condition, a running measurement can always be stopped by
pressing the REC key.
Depending on the duration of the recording, ensure that the battery is sufficiently charged. The
device can also be operated with the help of the USB charger so that measurements can be made
over a long period of time.
The data records can then be read out from the meter and displayed using the PC software.
© PCE Instruments
36