Storage And Transport; Decommissioning And Disposal; Device Replacement And Repair - Eaton ESR5-NO-21-24VDC Manual

4 Maintenance

4.2 Storage and transport

4.2.1 Decommissioning and disposal

4.2.2 Device replacement and repair

29
The device is delivered in cardboard packaging.
• Observe the handling instructions on and in the packaging.
￫
Transport the device exclusively in its original packaging or in
packaging suitable for transportation.
• For transportation and storage, observe the specifications regarding cli-
matic ambient conditions in the technical data for the temperature range,
humidity, and air pressure ￫ Page 41
For decommissioning, make sure to observe the requirements of the
machine or system manufacturer.
When decommissioning the system or parts of the system, make sure to
handle the used devices as follows.
If you will continue to use the device in conformity with its intended
use:
• Store and transport the device in conformity with the corresponding
specifications ￫ Section 4.2, "Storage and transport", page29
The device is no longer used:
ATTENTION
Devices no longer being used must be professionally disposed
or returned to the manufacturer or relevant sales department.
For more information, see
▶ Dispose of recyclables as required by your local recycling regulations.
The device can be replaced if necessary.
If replacing the device:
• Use the same device type
• Use the same or a higher hardware/firmware version.
CAUTION

DESTRUCTION
Repairs to the device, especially those involving opening the
housing, must be carried out exclusively by the manufacturer.
ESR5-NO-21-24VDC 11/23 MN049017EN Eaton.com
.
Eaton.com/recycling