6. IR Cable Pin Assignment
IR RECEIVER
Note: When the angle between the IR receiver and the remote control is ± 45 °,
the transmission distance is 0-5 meters; when the angle between the IR receiver
and the remote control is ± 90 °, the transmission distance is 0-8 meters.
7. EDID Management
This Matrix has 12 factory defined EDID settings, 2 user-defined EDID modes and
4 copy EDID modes. You can select defined EDID mode or copy EDID mode to
input port through RS-232 control or Web GUI.
RS-232 control operation: Connect the Matrix to the PC with a serial cable,
then open a Serial Command tool on the PC to send the ASCII command "s edid
in x from z!" to set EDID. For details, please refer to "EDID Setting" in the ASCII
command list of "RS-232 Control Command".
Web GUI Operation: Please check the EDID management in the "Input page" of
"Web GUI User Guide".
IR RECEIVER
8
IR Signal
Grounding
Power 12V