Installation Instructions for Restraining Device
1. Restraining Device should be installed parallel (in line)
with the power supply cord.
2. Restraining Device Parts List: See (Fig A) for a photo of
the materials contained in the Restraining Kit.
3. Attach Staple Bracket: Fasten the Staple Bracket (Fig B.)
to a stud located in the wall that the power receptacle is
located on. Use the (4) #10 x 1" screws and plastic anchors
if needed.
4. Install Eyebolt: Thread Jam Nut onto Eyebolt. Screw
Eyebolt into threaded hole above Power Cord connection
point on back of Oven. Tighten Eyebolt and then tighten
Jam Nut to keep Eyebolt tight (Fig C.).
5. Connect Restraining cable: Attach one end of cable using
the Spring Loaded Hook to the Eyebolt (Fig D.). Attach
other end of cable to the Staple Bracket using the other
Spring Loaded Hook (Fig E.).
6. Note: To provide strain relief the restraining cable must
be shorter than the power supply cord. The restraining
Device should always be connected when the oven is in use.
Figure C
Figure D
9 of 28
1
2
5
6
Figure A
1. Staple Bracket
2. Eyebolt with jam nut
3. Restraining Cable
4. Spring Loaded Hook
5. #10 x 1" Screws
6. Plastic Anchors
7. Instruction Sheet
Figure B
Figure E
Copyright 2013 by Southern Pride Distributing, LLC Volume 1
3
4
7