Table of Contents
Advertisement
Electrical
Ethernet:
One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)
Power:
Direct DC source: 12Vdc nominal, +/- 5%
Power over Ethernet (PoE): 802.3af complaint source
Connect only to IEC 60950-1 or IEC 60601-1 products and power sources.
If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL
listed, with an output rated 12Vdc, minimum 1A, marked "LPS" and "Class 2", and suitable for plugging into a
standard power receptacle in the US and Canada.
Environmental
Operating:
Temperature: 0°C to +40°C (+32°F to +104°F)
Humidity: 5% to 93% non-condensing
Storage and transport
Temperature: -40°C to +70°C (-40°F to +158°F)
BLE Radio Default State
When the Access Point is in factory default state the integrated BLE radio is enabled. This applies to the non-TAA/
FIPS product SKUs only. On the TAA/FIPS products, the BLE radio is disabled when the unit is in factory default
conditions. Once the AP has established a connection with its management platform, the BLE radio state is
updated to match what's configured there. This state is maintained if the AP is power-cycled or rebooted.
Console Port Default State
When the Access Point is in factory default state the console interface (both physical port and BLE) is enabled
with default credentials (username is "admin" and password is the serial number of the unit).
Once the AP has established a connection with its management platform, the console port state (enabled/
disabled) and access credentials are updated to match what's configured there. State and credentials are
maintained if the AP is power-cycled or rebooted.
USB Host Interface Default State
When the Access Point is in factory default state the USB host interface is powered and enabled, assuming the
AP is not in a restricted power mode. On some AP models the USB port may be disabled when a POE source with
insufficient power budget is used. Once the AP has established a connection with its management platform, the
USB host interface state is updated to match what's configured there. This state is maintained if the AP is power-
cycled or rebooted.
Regulatory Information
The following regulatory model names apply to the 303 Series access points:
AP-303: APIN0303
FCC
RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This
!
equipment should be installed and operated with a minimum distance of 13.78 inches (35cm) between the
radiator and your body for 2.4 GHz and 5 GHz operations. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Aruba 303 Series Campus Access Points
| Installation Guide
9
Advertisement
Table of Contents
