Electrical And Environmental Specifications; Regulatory Information - Aruba AP-334 Installation Manual

Electrical and Environmental Specifications

For additional specifications on this product, please refer to the product data sheet at
Electrical
Ethernet:

ENET0: 100/1000/2500 Base-T auto-sensing Ethernet RJ45 interface

ENET1: 100/1000 Base-T auto-sensing Ethernet RJ45 interface

IEEE 802.3u (100 Base-T). IEEE 802.3ab (1000 Base-T)

Power over Ethernet IEEE 802.3at 56VDC (nominal) and 802.3af 48VDC (maximum)

Power:

48VDC power interference, support powering through an AC-to-DC power adapter (AP-AC-48V36B)

Maximum power consumption (excluding USB): Refer to datasheet

If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL listed,
with an output rated 48VDC, minimum 2A, marked "LPS" and "Class 2", and suitable for plugging into a standard
power receptacle in the US and Canada.
Environmental
Operating:

Temperature: 0°C to +50°C (+32°F to +122°F)

Humidity: 5% to 93% non-condensing

Storage and transport:

Temperature: -40°C to +70°C (-40°F to +158°F)

Humidity: 5% to 93% non-condensing

!
For indoor use only. The access point, AC adapter, and all connected cables are not designed for outdoor use.

Regulatory Information

For the purpose of regulatory compliance certifications and identification, this product has been assigned a
unique regulatory model number (RMN). The regulatory model number can be found on the product nameplate
label, along with all required approval markings and information. When requesting compliance information for
this product, always refer to this regulatory model number. The regulatory model number is not the marketing
name or model number of the product.
AP-334/IAP-334 RMN: APIN334

AP-335/IAP-335 RMN: APIN335

Aruba Networks provides a multi-language document that contains country-specific restrictions and additional
safety and regulatory information for all Aruba access points. This document can be viewed or downloaded at
arubanetworks.com.
Changes or modifications to this unit not expressly approved by the party responsible for regulatory compliance
could void the user's authority to operate this equipment.
!
Toute modification effectuée sur cet équipement sans l'autorisation expresse de la partie responsable de la
conformité est susceptible d'annuler son droit d'utilisation.
Federal Communication Commission
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
Aruba 330 Series Access Points
| Installation Guide
arubanetworks.com
.
9