Operating Mode Description - PROLiNK Master II Series User Manual

l
09: Auto restart enable/disable
Interface
l
10: Minimum battery capacity to restart UPS again
Interface
l
11: Low battery state indication setting
Interface

3-6. Operating Mode Description

Operating mode
Online mode
ECO mode
Setting
Parameter 2: Enable or disable auto restart function. You may
choose the following two options.
ENA: auto restart enable(Default)
DIS: auto restart disable
Setting
Parameter 2: Set the minimum battery capacity by pressing
the Down key or Up key.
There are four options: 0%, 15%, 50%, 90% (Default: 0%) 15%: When 15%
is selected, the UPS is discharged until battery automatically shut
down during power failure. After the utility power is restored, the UPS
will automatically
restart when battery capacity is greater than 15% again.
Setting
Parameter 2: Set the remaining battery time to trigger the low battery
warning by pressing the Down key or Up key.
There are four options: 2 min, 5 min, 7min, 10min
2min: When 2min is selected and the remaining battery discharge
time in battery mode is less than 2min, the UPS will activate "Battery
Low" alarm. The alarm will continuously sound for 2 minutes.
Note: If "Battery Low" alarm is triggered, the alarm will continuously
sound until the setting time is achieved.
Description
When the input voltage is within acceptable range,
UPS will provide pure and stable AC power to output.
The UPS will also charge the battery at online mode.
Energy saving mode:
When the input voltage is within voltage regulation
range, UPS will bypass voltage to output for energy
saving. The UPS will also charge the battery at ECO
mode.
18
LCD display