Ups Setting - PROLiNK Master II Series User Manual

BR
EE
BC
BO
EL
RST
NUL
CLO

3-5. UPS Setting

l
01: Output voltage setting
Interface
l
02: Converter enable
Interface
Battery Replace
EEPROM error
Lithium battery communication loss
Lithium battery over temperature
The battery is nearing its complete life.
Automatic restart
No operation
Shield lithium battery EOL warning for one week
Three parameters need to be configured in order to set up
the UPS. Refer to following diagram.
Parameter 1: It is for the program alternatives. Refer to the
below table.
Parameter 2 and parameter 3 are the setting options or
values of each program.
Setting
Parameter 2: Output voltage setting
For 220/230/240 VAC models, you may choose the following output
voltage.
220: presents output voltage is 220Vac
230: presents output voltage is 230Vac (Default)
240: presents output voltage is 240Vac
Setting
Parameter 2: Enable or disable converter mode. You
may choose the following two options.
CF ENA: converter mode enable
CF DIS: converter mode disable (Default)
15