Table of Contents
Advertisement
APC-2138
Item
Wake system from S5
3.6.2.9
USB Configuration
The USB Configuration menu helps read USB information and configures USB settings.
Item
USB transfer time-out
Device reset time-out
Device power-up delay
Mass Storage Devices
42 APC-2138 Quick Reference Guide
Options
Enable or disable System wake on alarm event. Select
Disabled[Default],
FixedTime, system will wake on the hr::min::sec
Fixed Time
specified. Select DynamicTime, System will wake on
Dynamic Time
the current time + Increase minutes(s).
Option
1 sec
5 sec
10 sec
20 sec[Default]
10 sec
20 sec[Default]
30 sec
40 sec
Auto[Default]
Manual
Auto[Default]
Floppy
Forced FDD
Hard Disk
CD-ROM
Description
Description
The time-out value for Control, Bulk, and Interrupt
transfers.
USB mass storage device Start Unit command
time-out.
Maximum time the device will take before it properly
reports itself to the Host Controller. 'Auto' uses
default value: for a Root port it is 100ms, for a Hub
port the delay is taken form Hub descriptor.
Mass storage device emulation type. 'AUTO'
enumerates devices according to their media format.
Optical drives are emulated as 'CDROM', drives with
no media will be emulated according to a drive type.
Advertisement
Table of Contents
