Table of Contents
Advertisement
Attaching to Wall Anchor Method
For attaching mounting bracket to hollow walls (wall areas between
studs) or solid walls (concrete or masonry):
1.
Drill holes at marked locations using 5/16-inch drill bit. For solid
walls (concrete or masonry), drill at least 1 inch deep.
2.
Fold wall anchor as shown in Figure 7.
3.
Insert wall anchor (wings first) into hole. Tap anchor flush to
wall.
4.
For thin walls (1/2 inch or less), insert red key into wall anchor.
Push red key to "pop" open anchor wings (see Figure 8).
IMPORTANT: Do not hammer anchor key! For thick walls (over
1/2 inch thick) or solid walls, do not pop open wings.
5.
Place mounting bracket onto wall. Line up last hole on each end
of bracket with wall anchors.
6.
Insert mounting screws through bracket and into wall anchors.
7.
Tighten screws until mounting bracket is firmly fastened to wall.
Placing Heater On Mounting Bracket
1.
Locate two horizontal slots on back panel of heater (see Figure
9).
2.
Place heater onto mounting bracket. Slide horizontal slots onto
stand-out tabs on mounting bracket.
Installing Bottom Mounting Bracket
1.
Install bottom bracket to heater bottom with two screws. It may
be more convenient to remove heater from wall bracket to at-
tach.
2.
Place heater on wall mounting bracket.
3.
Mark screw locations on wall.
4.
Remove heater from mounting bracket.
5.
If installing bottom mounting screws into hollow or solid wall,
install wall anchors. Follow steps 1 through 4 under "Attaching
To Wall Anchor Method". If installing bottom mounting screw into
wall stud, drill holes at marked locations using 9/64-inch drill bit.
6.
Replace heater onto mounting bracket.
7.
Tighten both screws until heater is firmly secured to wall. Do not
over-tighten.
Figure 7 - Folding Anchor
Figure 8 - Popping Open
Figure 9 - Mounting Heater
Anchor Wing For Thin Walls
Onto Mounting Bracket
Figure 10 - Installing Bottom
Mounting Bracket
Advertisement
Table of Contents
