Table of Contents
Advertisement
LOCATING HEATER
This heater is designed to be mounted on a wall. For convenience and
efficiency, install heater:
1) where there is easy access for operation, inspection, and service.
2) In the coldest part of room.
FASTENING HEATER TO WALL
Mounting Bracket
The mounting bracket is located on back panel of heater (see Figure 4).
It has been taped there for shipping. Remove mounting bracket from
back panel.
Removing Front Panel of Heater
1. Remove two screws near bottom corners of lower front panel .
2. Pull bottom of lower front panel forward, then down (see Figure 5).
Methods For Attaching Mounting Bracket To Wall
Use only the last hole on each end of mounting bracket to attach bracket
to wall. Attach mounting bracket to a wall only in one of two ways:
1.
Attaching to wall stud: This method provides the strongest hold.
Insert mounting screws through mounting bracket and into wall studs.
2.
Attaching to wall anchor: This method allows you to attach mounting
bracket to hollow walls (wall areas between studs) or to solid walls
(concrete or masonry).
3.
Decide which method better suits your needs. Either method will provide
a secure hold for the mounting bracket.
Marking Screw Locations
1.
Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
WARNING: Maintain minimum clearances shown in Figure 3. If you can, provide greater clearances from floor
and joining wall.
2.
Mark screw locations on wall (see Figure 6).
Note: Mark only last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.
Remove tape and mounting bracket from wall.
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and spacers are in hardware package. The hardware package is provided with
heater.
Attaching to Wall Stud Method
For attaching mounting bracket to wall studs:
1.
Drill holes at marked locations using 9/64-inch drill bit.
2.
Place mounting bracket onto wall. Line up last hole on
each end of bracket with holes drilled in wall.
3.
Insert mounting screws through bracket and into wall studs.
4.
Tighten screws until mounting bracket is firmly fastened to wall studs.
Figure 4 - Mounting Bracket Location
0
Figure 5 - Mounting Bracket
Clearances (inches)
Figure 6 - Mounting Bracket
Clearances (inches)
Advertisement
Table of Contents
