Setup
Check for Dial Tone
After the batteries are charged, pick up the handset and press
should hear a dial tone.
Set Time and Date
If you subscribe to caller ID service, the date and time will be set automatically with
the first incoming call. If you do not have caller ID service, you can set the date
and time manually.
• Press PROG, and then press
SELECT.
• The month is flashing. Press
month. Press SELECT.
• The day is flashing. Press
Press SELECT.
• The hour is flashing. Press
Press SELECT.
• The minute is flashing. Press
minute. Press SELECT.
• AM or PM is flashing. Press
Wall Mounting
The wall mount bracket is designed for use on standard wall mount plates only.
1.
Run the power and telephone line cords through the slots in the bracket,
connecting them to the jacks located on the underside of the base.
2.
Plug the AC adapter into an electrical outlet. If the battery has not been
previously charged, place the handset in the base, and allow it to charge for
10-12 hours (or overnight).
3.
Connect the telephone line cord to the wall jack.
4.
Line up the tabs on
the
wall
mount
bracket with the slots
on the bottom of the
base unit. Snap the
bracket firmly in
place.
5.
Mount the base on
the wall. Position the
base unit so the
mounting studs will fit
into the holes on the
wall mount bracket.
Slide the base unit
down on the mount-
ing studs until it locks
into place.
or
until DATE/TIME is displayed. Press
or
until the screen displays the correct
or
until the screen displays the correct day.
or
until the screen displays the correct hour.
or
until the screen displays the correct
or
to choose AM or PM. Press SELECT.
8
/FLASH , you