Connect The Charger; Charge The Battery; Check The Battery Level; Check For Dial Tone - VTech VS 113 User Manual

Connect the charger

NOTES
• Use only the adapters provided.
• Make sure the electrical outlets are
not controlled by wall switches.
• The adapters are intended to be
correctly oriented in a vertical or floor
mount position. The prongs are not
designed to hold the plug in place if
it is plugged into a ceiling, under-the-
table or cabinet outlet.

Charge the battery

Place the handset in the telephone base
or charger to charge.
Once you have installed the battery, the
handset LCD display indicates the battery
status (see the table below).
Battery Battery Action
indicators status
Battery has no Charge without
The screen is
charge or very interruption
blank or shows
little (at least 30
Put in charger
charge. The minutes).
handset cannot
and flashes.
be used.
The screen Battery has Charge without
shows enough charge interruption
Low battery to be used for a (at least
short time. minutes).
and flashes.
To keep
the battery
charged,
The screen
Battery is place it in the
shows
charged. telephone base
HANDSET X.
or charger
when not in
use.
When it is fully charged, you can expect
the following performance:
Operation Operating time
While in handset use
10 hours
(talking*)
While not in use
5 days
(standby**)
* Operating times vary depending on
your actual use and the age of the battery.
** Handset is not charging or in use.
18
NOTES
• Place the handset in the charger will
bypass the set date and time, and
voice guide.
• For best performance, keep the
handset in the charger when not in
use.
• The battery is fully charged after 16
hours of continuous charging.
• If you place the handset in the charger
without plugging in the battery, the
screen displays NO BATTERY.
30

Check the battery level

After you have installed the battery,
check the battery level on the handset
screen.
• If the battery icon is , or , then
go to Set the date and time and
the answering system through voice
guide.
• If the screen is blank, or flashes, then
the battery needs to be charged. Go
to Charge the battery before you do
any setting or operation.

Check for dial tone

Press HOME/FLASH. If you can hear
a dial tone, the installation is successful.
If you do not hear a dial tone
• Make sure the installation procedures
described above are properly done.
• It may be a wiring problem. If you
have changed your telephone
service to digital service from a cable
company or a VoIP service provider,
the telephone line may need to
be rewired to allow all existing
telephone jacks to work. Contact
your cable/VoIP service provider for
more information.
19
Set