Table of Contents
Advertisement
Switch action
1
2
Fig.4
► 1. Suction power change button 2. ON/OFF button
To start the cleaner, simply push the ON/OFF button. To
switch off, push the ON/OFF button again.
You can change the suction power of the cleaner in
four steps by pushing the suction power change button.
Each push on this button repeats the Quiet/Normal/
High/Max mode in a cycle.
Level
1
2
3
4
PARTS DESCRIPTION
Country specific
2
1
Fig.6
1
250 mL dust case
(Optional accessory)
High performance filter
5
(Filter frame in gray color)
(Optional accessory)
Hand strap (Country specific)
9
4
3
2
1
Indication
Mode
Quiet mode
Normal speed mode
High speed mode
Max speed mode
2
400 mL dust case
(Optional accessory)
HEPA filter (Filter frame
6
in white color) (Optional
accessory)
-
-
NOTE: You can change the suction power before
turning on the cleaner.
NOTE: The cleaner starts the operation with the
same suction power as the last operation.
Lighting up the lamp
CAUTION:
source of light directly.
To turn on the lamp, push the suction power change
button. The lamp goes off in approximately 10 seconds.
While the cleaner is running, the lamp turns on.
The lamp goes out approximately 10 seconds after
stopping operation.
NOTE: When the remaining battery capacity gets low,
the lamp starts blinking. The timing, at which the lamp
starts blinking depends on the temperature at work
place and the battery cartridge conditions.
1
2
Fig.5
► 1. Suction power change button 2. ON/OFF button
3. Lamp
3
4
Mesh filter
3
7
Sponge sheet
-
6 ENGLISH
Do not look in the light or see the
5
7
6
4
Cyclone body
8
Cleaner body
-
-
3
8
9
-
Advertisement
Table of Contents
