Makita CL003GM107 Instruction Manual page 15

Disassemble the mesh filter into three compo-
3.
nents: prefilter, tubular sponge filter and mesh pipe.
i Squeeze the guide stoppers on top of the mesh
pipe together.
ii Pass the guide stoppers down through the guide
hole on top of the prefilter.
iii Pull the the prefilter along the tubular sponge filter
and mesh pipe.
iv Remove the tubular sponge filter from the mesh
pipe.
4
5
Fig.44
► 1. Prefilter 2. Tubular sponge filter 3. Mesh pipe
4. Guide stoppers 5. Guide hole
Wipe and shake dust off the filters and mesh pipe
4.
by hand.
Fig.45
2
1
Wash the filters and mesh pipe in soapy water
5.
when they are clogged with dust and dirt. Dry them out
thoroughly in the shade before use.
3
Fig.46
Reassemble the mesh filter.
6.
i Insert the tubular sponge filter into the prefilter.
ii Insert the mesh pipe into the tubular sponge filter
and prefilter, passing the guide stoppers on top of the
mesh pipe through the guide hole on top of the prefilter.
iii Push the mesh pipe through the tubular sponge
filter and prefilter until it lock in place with a click.
1
1
5
Fig.47
► 1. Prefilter 2. Tubular sponge filter 3. Mesh pipe
4. Guide stoppers 5. Guide hole
15 ENGLISH
2
3
4